Poly naphthalene sulfonate formaldehyde

Poly Naphthalene Sulfonate Formaldehyde is high range water-reducing and an anion surface active agent based on polyalkyaryl- sulphonate.

Technical spefication:
Solid Content 92% min
Moisture 8.0 % max
Fineness 5.0% max
PH value 7 - 9
Chlorides Content 2.0% max
Surface Tension 68-72 Mn/m
Cement Flowing Rate 230mm min
Concrete Reducing Water Rate 18% min
Sodium Sulfate Content 18% max (5%max is also available)

Uses
Poly Naphthalene Sulfonate Formaldehyde produces concrete with extremely workable characteristics referred to as high slump. PNS also allows concrete to be produced with very low water/cement ratios at low or normal slumps.
Poly Naphthalene Sulfonate Formaldehyde is ideal for use in prestress, precast, bridge deck or any concrete where it is desired to keep the water/cement ratio to a minimum and still achieve the degree of workability necessary to provide easy placement and consolidation.

Addition Rates
Poly Naphthalene Sulfonate Formaldehyde can be added directly or added in after melt. It can be added during mixing and after-mixing. The afterward approach can achieve better result. The suggested addition rate is 0.75%.

Poly Naphthalene Sulfonate Formaldehyde Direction
Prepare solutions as required.
Direct use of powdery agent is allowed. Alternatively the addition of the agent is followed by water moisturization (water-cement ratio: 60%).
The agent can be combined with other externally applied agents if pilot development or laboratory experiment succeeds.

Packing of Poly Naphthalene Sulfonate Formaldehyde:
Packed in plastic film bag wrapped with plastic woven sack with a net weight of 25kg each.

MSDS---SNF